AbleData does not produce, distribute or sell any of the products listed on this website, but we provide you with information on how to contact manufacturers or distributors of these products. If you are interested in purchasing a product, you can find companies who sell it below.
The Challenger PP, model 5500, is a powered wheelchair designed for use by adults with lower extremity, mobility, or neurological disabilities or spinal cord injury. FRAME (HxLxW): 34 to 35 x 43 x 25 inches. The frame length without footrests is 31 inches. The turning radius with footrests is 19.5 inches. The one-piece polyester-coated power base frame is available in midnight blue and burgundy red; the seat frame is black. Front anti-tippers are included. CONTROLS: Integrated programmable Integra joystick controller. An optional programmer for the controller is available. FWD: Front-wheel drive with two direct drive right angle gear 0.5-horsepower motors. SEAT (LxW): 16 x 18 inches. The back height is 18 inches and a headrest is standard. The floor-to-seat height is 20 inches. A seat belt is standard. UPHOLSTERY: Black padded nylon upholstery. ARMRESTS: Swing-back padded armrests adjust to accommodate widths from 19 to 26 inches. CASTERS: 8 x 2 inch cast aluminum rear caster wheels with air foam tires. WHEELS: 14 x 3 inch cast aluminum front wheels with pneumatic tires and puncture-resistant tubes. FOOTRESTS: Front one-piece footplate. The rigging length is 17 to 19 inches. OPTIONS: IV rod attachment; rear mount shopping basket; tray; and oxygen tank holder. POWER: Uses two deep cycle U-1 batteries (not included) with a 3-amp, 24-volt internal charger. A 10-amp external charger and a direct battery charge harness are optional. SPEEDS: 4.8 miles per hour for a range of up tp 25 miles per charge. CAPACITY: 250 pounds. WEIGHT: 104 pounds.
print close directions